@KYOSHO.Co. StreamLiner scale-up(6) |
Work of a carry trailer
To the inside as which
the real photograph is regarded
Carry became wanting.
It made ,most quality of the materials are aluminum. |
|
It sells at a Home-Center (a aluminum L-angle ,an square pipe, and C channels are the main material. )
The beginning, the surface being burned and becoming dirty, although aluminum
wax attachment was tried -- I understand that raw [ baked ] was carried
out and intensity fell, and it gave up
It will be bent and processed.
|
the under -- "wax attachment": the upper --" bending"
|
It's so hard with original aluminum-- since it does not elapse and bend
It roasts over a gas burner moderately.
It becomes so soft that it will bend simply by slight power if it
roasts too much. A few is roasted and it bends. Intensity is maintained as much
as possible by this repetition. |
|
Processed thing It has stopped
by the blind rivet.
Later, the place where decomposition is unnecessary uses a rivet
stop, and a required place uses a screw. |
|
A main frame is 9mm angle pipe of
aluminum.
Since the diameter of inner is 7mm angle 7mm rods is used for a joint about
2cm in the portion of T character junction.
It has deleted aslant. In order to use the angle pipe which bent
the keel portion of a ship into "the character to a contrary", it becomes T
characters of about 75 degrees on a frame, and the hitting portion is deleted.
|
|
Adhesion material is
this. It is sticky by translucence. Aluminum can also be pasted up so so.
|
|
A tire is attached in a frame. They
are parts.
A tire, a board spring, and related parts ordered the parts of the radio
control tank trailer of TAMIYA.
|
|
It attached.
A position is decided, seeing the balance when placing a ship. |
|
The amount of [ for which a shaft uses all screws ] shaft
central part covers in an aluminum pipe. |
|
A tire is attached and the tread (width between tires) is
decided. |
|
The bar in contact with a ship's bottom is made from C
channels
|
|
Various things are built |
|
A tire fender is made. Since the diameter of a tire is 95mm The
about 105-110mm can was looked for. It cuts to two equal parts.
Although it is writing that it searched simply, this has taken long time.
|
|
In order to attach a tire fender in
a frame
"L angle" is attached. Then, silver are painted. |
|
completed |
The black stick is a rubber pipe, step is an aluminum punching panel. |
|
Pipe detour processing of a screw portion
A board spring also functions firmly (right figure). |
|
Good ! |
|
Top-page-> |