Hercures-Steam-Tagboat(SAITO.Co JAPAN)--2
It is a paper pattern about the teak material of a deck. It is alike and a double-sided tape is stuck. Wood is placed. At this time, they are adhesives. bat It is not used now A genuine article is in the crevice between a wood and a wood. Black rubber (coal tar ?.) -- it -- wooden expansion and contraction It seems that it . In order to reproduce it It is the wooden side with water magic pen It applies beforehand.		Being [ it / water ]-why ? ... It is since an oil paint is applied later. It is because it will spread if oily magic is used. Oily magic is used when using distemper later
The deck portion of a the ship		Sailboat of the Republic of Korea of the Nagasaki sailing boat festival I has forgotten before a name.
Some junction of a deck has a kind. It is 10cm to reference about the figure. If it is a scale 1:40 It becomes in width 20cm and length 4m. Good size A crack is put into 10cm unit with a graver!
It is from a reverse-side side about a TITEBOND2(water proofed). The figure to apply It is a spatula about a bond to a crevice here. It stencils.
Rear side deck The place which is removing the paper Front side (photograph right-hand side) The deck with a kit (Although it was going to reproduce grain before) Since it was not pleased, it was made teak tension. The deck of a real ship is more whitish wood. Become showy as a model this time. Blackish teak material was chosen.
Stretching a deck is finished 90%. If it thinks that a house will be built The position of a chimney is not known. A unit is attached .
Since it will be hard to attach a burner if it is the position of a drawing The whole will be raised 5mm - 10mm. After design change Since the deck front part goes up by about 1.5cm, although it is satisfactory It is painful when it is drawing plan sheet It seems that it is somewhat tight to Hercles since the boiler of the Saito factory's boiler is longer 4cm than a first stage type.
An alignment of a shaft They are a rudder and a support portion in passing.
It rests just for a moment. The regular meeting of a sailing boat model If alike and present Good ship It is Carmen II. It becomes radio control and does not become precocious. It is the fishing boat of Spain. Yes, let's build our own ship.
An old material is also used. Back sheet is wroted newly drawing plan.
To the inside currently made There is specification change finely. Although it is usual ...
The form was made considerably. The kit of Saito, such as form, finish, and a feeling of quality Although the age of 20 - 30 years ago is aimed at
It continues to the next (a molding thing and paint)
Top-page->