KYOSHO.Co. StreamLiner scale-up(3)
The motor which was attached when it bidded on an auction The marine motor for the water-cooled formula. The axis is a pipe and water passes.
The lining of plywood is made a opening. Since the thin plywood for models etc. seldom has visible grain, it is using the lauan plywood which is cheap one (3mm). It colors by oil stain color. Clear lacquer or an urethane paint is applied. In order that I may serve also as adhesion The epoxy resin is used. Two holes are visible. Since it is in an accessory case, the step which applies a leg?, or a genuine article?, it has opened. If it sees from the reverse side A frame is constructed by wood-lods, and it is lid by scrap plywood
Since plywood is hard, it presses down by C clamp. A crevice is fill uped with the roving + epoxy resin of a glass-fiber. (Refer to the column of Lib adhesion of Heracles)
Edge of deck uses the rubber which presses down a screen door. A section is the star form whose hole suited. There is also sorts [ several ] thickness. It cuts by the cutter, carries out and inserts in C type section, and is adhesion at the moment.
The base of a sofa uses the thing of the original plastic. To this The synthetic skin is due to be stuck.
It continues to the next 04
Top-page->